Cybex CX-445T - Manual (Page 19)

11. Press the Pause/Stop key at any time to stop your workout. Press Pause/Stop once to
end your workout and begin your Workout Review. As you press Pause/Stop once, the
treadmill belt will stop. Press Pause/Stop a second time to clear the Workout Review,
return to Dormant Mode and return incline to 0%.
12. If the e-stop key is removed during a workout, the drive motor power shuts off
immediately, causing the belt to stop. The right window changes to “OFF” and the left
window shows a flashing pattern of “o” and “o”. Replacement of the e-stop key causes
Workout Review to begin. Pressing Quick Start will resume your workout.
13. When you complete a program the treadmill begins a countdown, “3...2...1,” and sounds
a tone for each count. The belt slows to a stop and Workout Review displays in the center
window for the preset time or until you press the Pause/Stop key.
14. The treadmill returns to Dormant Mode and the incline returns to 0%
Stopping the Treadmill
Press Pause/Stop once to pause your workout for up to 20 seconds (or time set for idle) and
to enter the Workout Review. The belt will stop and workout data will remain in memory for
the duration of pause. Press the Quick Start key within 20 seconds to continue your workout
and add to the time you already accumulated. If the Quick Start key has not been pressed
during the duration of pause, workout data will be cleared and the display will change to
Dormant Mode.
9. Press the Speed + — keys to change the belt speed at any time. The right display will
show the set speed.
10. Press the Incline keys to change the incline at any time. The left display will show
the current incline only when incline keys are used, then revert to time.
Cybex 445T Treadmill Owner’s Manual
Figure 1
Operation
Page 3-4
Cybex International, Inc. Medway, MA USA (508) 533-4300 www.CybexInternational.com Wireless HR Receiver Inside
HR
control
programs
manual
VOLUME CHANNEL