Cybex CX-445T - Manual (Page 46)

Service Schedule
All maintenance activities shall be performed by qualified personnel. Failure to do so could
result in serious injury.
NOTE: This is the minimum recommended service.
1. Determine mileage.
A. While in Dormant Mode enter Test Mode by pressing and holding the Pause/Stop key
for five seconds.
B. Press the Dist key. DIST appears on the display. Record Mileage. NOTE: Once the
unit exceeds 999 miles or kilometers the odometer will use both screens. Example:
12,805 miles or km would be displayed as 12 805 .
NOTE: To exit Test Mode, press the Pause/Stop key .
First 500 miles (800 km).
• Check running belt tension and tracking.
Every 5,000 miles (8,000 km).
• Check running belt tension and tracking.
• Move treadmill and vacuum underneath.
• Raise elevation to 15%, Carefully tip treadmill up on the console to clean underneath
with a dry cloth and vacuum. Return to normal position when done.
Every 12,000 miles (19,300 km).
• Replace running belt and flip deck.
• Replace deck bumpers.
• Replace drive motor brushes.
• Check elevation assembly and replace worn parts.
• Lubricate elevation pivot points.
NOTE: Every 12,000 miles (19,300 km) the unit will show “SVC” on the display. The unit will
then emit a short beep every 2 minutes. This will continue until the service is performed
and the service odometer is reset.
Every 24,000 miles (38,600 km).
• Replace running belt and deck.
Cybex 445T Treadmill Owner’s Manual
Preventive
Maintenance
Page 4-6