Vermont Casting GPFMP - Manual (Page 10)

10
Vermont Castings Gas Patio Fire
Operation
Upon completing the gas line connection, a small
amount of air will be in the lines. When first lighting the
burner, it will take a few seconds for the lines to purge
themselves of this air. Once the purging is complete,
the burner will light and operate as indicated in the
instruction manual. Subsequent lighting of the appli-
ance will not require such purging. WARNING: Read and follow the Safety and Lighting
Instructions page in this manual and on labels on the
appliance. IF YOU DO NOT FOLLOW THESE IN-
STRUCTIONS PRECISELY, A FIRE OR EXPLOSION
MAY RESULT AND YOU MAY BE SERIOUSLY IN-
JURED!
Lighting and Operating Instructions
FOR YOUR SAFETY, READ BEFORE LIGHTING
WARNING: If you do not follow these instructions exactly, a fire or explosion
may result causing property damage, personal injury or loss of life.
A. This appliance must be lit manually. When lighting,
follow these instructions exactly.
B. BEFORE LIGHTING smell all around the appliance
area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance
• Do not touch any electric switch
• Do not use any phone in your building
• Immediately call your gas supplier from a neighbor’s
phone. Follow the gas supplier’s instructions
• If you cannot reach your gas supplier, call the fire
department
C. Use only your hand to turn the gas control key.
Never use tools. If the key will not turn by hand, do
not try to repair it, call a qualified service technician.
Applying force or any attempted repair may result in
a fire or explosion.
D. Do not use this appliance if any part has been under
water. Immediately call a qualified service technician
to inspect the appliance and to replace any part of
the gas control which has been under water.
Lighting Instructions
1. STOP! Read the safety information above.
2. Remove the cover.
3. Insert the “TEE” handle in the valve.
4. Hold the log lighter towards the center of the burner.
• For Natural Gas unit, turn the “TEE” handle
slowly counterclockwise
.
• For LP unit, turn valve on the LP tank counter-
clockwise
all the way and then turn the
“TEE” handle on the valve slowly counterclock-
wise
.
5. If the burner does not light immediately, turn the gas
valve to “OFF”.
6. Wait at least five (5) minutes to clear out any gas.
Then smell for gas, including near the floor. If you
smell gas, STOP! Follow “B” in the safety informa-
tion above. If you do not smell gas, repeat steps.
To Turn Off Gas to Appliance
1. Turn the “TEE” handle to the “OFF” position, fully
clockwise at the unit, then turn the valve on
the LP tank to the “OFF” position, fully clockwise
. Remove “TEE” handle.
2. Replace cover, when unit has completely cooled.