Vermont Casting GPFMP - Manual (Page 8)

8
Vermont Castings Gas Patio Fire
3. Place volcanic rock evenly around and on burner
pan if you have not already done so. (Fig. 10)
4. Place log C1 on burner, using locator pins and
holes in bottom of log. (Fig. 11)
Log C1
LG162a
Fig. 11 Place log C1 on locator pins onburner.
5. Move around so that flex line is now on your right.
Place log C2 with “Y” part of log toward the outside
of the burner ring. (Fig. 12)
Log C2
Log C1
LG163a
Fig. 12 Log C2 placement.
6. Place logs C3 and C4 with flex line on your left. C3
fits just under angle of log C2. (Fig. 13)
7. Log C4 rests with ends of “Y” section on burner ring.
Top of log rests on log C2.
8. Flex line on right. Place log C5 with the notch at the
top resting next to log C3. (fig. 14)
9. Flex line on left. Place log C6 so the top of the log is
over log C3 and bottom of log is over corner of the
burner pan. (Fig. 15)
CAUTION
The logs are fragile. Use caution when placing the
cover on, or removing the cover from, the unit to
avoid damaging the logs.
Log C4
Log C2
Log C1
Log C3
LG164a
Fig. 13 Logs C3 & C4 placement.
Log C5
Log C4
Log C2
Log C1
LG165a
Fig. 14 Log C5 placement.
Log C5
Log C4
Log
C1
Log C6
Log C2
Log C3
LG166a
Fig. 15 Log C6 placement.