Scientech H410 Vector - Manual (Page 9)

9
U
NPACKING
:
The meter, detectors, and accessories are shipped in custom packing materials. All packing materials should be
saved for future damage free shipments.
If using the AC battery charger, verify that the electrical outlet is compatible with the charger. When using a
charger, the H410 will operate with or without batteries installed. However, if batteries are installed, they must
have a minimum charge of approximately 1 hour before the H410 will turn on, even if the AC battery charger is
used.
The H410 also runs off of four AA rechargeable batteries, which provide approximately 6 hours of usage before
requiring recharge. To recharge the batteries connect the charger to the indicator and the appropriate electrical
outlet. Allow 16 to 20 hours for a full charge.
C
HANGING OR
I
NSTALLING
B
ATTERIES
:
Warning: Use only Ni-MH or NI-Cad rechargeable batteries. If non-rechargeable
batteries are used with the battery charger the batteries may burst and cause
damage to you or the indicator.
Note: Dispose of used batteries according to local regulations.
To install batteries refer to Figure 3 and proceed as follows:
1. Loosen the screw holding the battery compartment cover.
2. Remove the old batteries if necessary.
3. Observing the polarity, install the new batteries.
4. Replace the cover and charge the batteries for 16 to 20 hours.
Figure 2 Figure 3