SIG SAUER SIG50 - Manual (Page 44)

44 www.sigsauer.com
6. To reinstall the firing pin assembly, first apply grease at both locking tabs located on the cocking piece housing. grasp
the bolt with your left hand with the back of the bolt facing to the right. install the firing pin assembly into the back of
the bolt while aligning housing tabs with the notches in the bolt body. When aligning the tabs, the cocking piece should
be positioned to the right of the cocking cam and notch (lH models will be to the left). With the palm of your right hand,
firmly press the firing pin assembly in until it bottoms out on the rear of the bolt. once fully depressed, rotate the firing
pin assembly counter clockwise.
7. you will feel the firing pin assembly lock in place.
8. grease the locking lugs and cocking cam of the bolt. install bolt in receiver making certain the bolt stop/guide has
“clicked” into its track in the bolt body.