SIG SAUER SIG50 - Manual (Page 46)

46 www.sigsauer.com
FIGURE 10: BOLT STOP RELEASE
Bolt Release
9.1 field strip Reassembly / function check
1. Point the rifle in a safe direction.
2. Move the safety lever to the rear (Safe) position.
3. align the lugs on the bolt at 12 and 6 o’clock.
noTe: The magazine follower must be depressed to allow the bolt to
enter the receiver.
4. Slide the bolt assembly into the receiver approximately halfway and
rotate it until the bolt stop/guide clicks into its track.
5. To lock the bolt assembly into position, push the bolt handle down.
6. engage safety by moving safety lever to the rear.
7. Press the trigger. Hammer should not fall.
8. disengage safety lever by pressing it forward.
9. Press trigger.
10. Hammer should fall.
alWayS PerforM a funcTion cHecK of THe rifle anyTiMe you field STriP iT for cleaning or MainTenance.
folloW THe STePS aBoVe. SHould THe rifle noT PaSS THeSe SiMPle STePS do noT aTTeMPT To fire THe rifle, and
conTacT Sig Sauer
® or an auTHoriZed SerVice TecHnician.