Speeco 40100500 V2 User Manual
Page 13
MAINTENANCE
1)
Switch off and unplug power cable before performing any maintenance, adjustment or repair. Make sure to remove any tools and accessories
from the work work area when done.
2)
Always check the oil level of the hydraulic reservoir before operation. Operating the log splitter without an adequate oil supply will
cause severe damage to the pump.
3)
Wipe the unit after use with an oiled rag to prevent rust.
4)
The hydraulic system is preset at the factory. Do not adjust the valve.
5)
If the ram moves slowly or erratically, there may be air in the system or insufficient hydraulic oil. Check the level of the hydraulic oil
with the dipstick.
6)
For other hydraulic and motor problems not addressed in this manual, please contact a qualified specialist.
7)
If the wedge becomes dull or nicked, it can be sharpened. ALWAYS wear safety gloves while handling the wedge.
8)
See also Repair and Maintenance Safety in the Safety Information section of this manual on page 5 of this manual.
5)
All replacement parts must meet manufacturer’s specifications.
NOTE: If the motor is overloaded for a long time, the thermal protector will disconnect the power of the motor. Switch off and unplug the power cord
to cool down the motor for 30 minutes. Restart the motor and the log splitter should operate again.
NOTE: Switch off and unplug the power cable quickly if the machine is acting abnormal. Contact our customer service department at 1-800-525-8322
to address these concerns.
Electric Circuit Diagram
Note: The main conection must have
maximum 16A fuse.
A.
Power cable
B.
Switch
C.
Wiring board
D.
Motor lead wire
E.
Thermal protector
F.
Main winding
G.
Auxilliary winder
H.
Capacitor
Hydraulic Circuit Diagram
A,
Hydraulic tank
B.
Oil filter
C.
Oil pump
D.
Electric motor
E.
Relief valve
F.
Control handle
G.
Cylinder
Page 11