Speeco 40100500 V2 - Manual (Page 5)

ER
PREPARATION OF THE LOG
Both ends of the log should be cut as square as possible to help prevent the log from riding out of the splitter during
operation. Do not split logs greater than 21 in. in length.
WORK AREA
NEVER operate the log splitter on slippery, wet, muddy or icy ground.
ONLY operate your log splitter on a level surface. Operating on a slope could cause the log splitter to roll over or logs to fall
off.
ALWAYS keep children away from the log splitter. All visitors should be kept a safe distance from the work area.
NEVER operate your log splitter in a damp or rainy environment to avoid electric shock or short circuit.
ALWAYS block the wheels to prevent movement of the log splitter while in operation.
ONLY operate your log splitter in daylight or under good artificial light.
ALWAYS keep the work area clean. Remove split wood around your log splitter immediately so that you don’t stumble
over it.Cluttered areas and benches invite accidents.
OPERATION OF THE LOG SPLITTER
Page 3
ALWAYS ensure the motor is properly grounded or apply protection device. Only use rubber-jacketed cable of sufficient lead
cross section as an extension cable.
ALWAYS split wood in the direction of the grain only.
ALWAYS hold the sides of the log when loading it on the splitter.
KNOW how to stop the log splitter and disengage the controls before operating it.
NEVER place hands, feet or any body part between the ram and splitting wedge during forward or reverse stroke. Serious
injury or death could result.
ALWAYS keep hands away from the ram, wedge and partly split logs.
NEVER straddle or step over the log splitter during operation.
NEVER move the log splitter while the motor is running. Shut off the motor even if you are leaving the log splitter for a short
period of time.
NEVER leave the machine unattended during operation. Turn power off and wait until it comes to a complete stop.
ALWAYS operate this log splitter from the “operator zone.” This is the area behind the wheels and control handle.
ALWAYS make sure the power switch is in the OFF position before plugging in the cord to avoid unintentional starting.