Cabletron Systems MicroMMAC 24T MICROMMAC- - Manual (Page 17)

INTRODUCTION
1-9
Figure 1-3. Typical Stackable Configuration
NOTE : Token Ring HubSTACK Interface cables, which are used to
connect between the MicroMMAC-T and stacked STH hubs, are not
included with the MicroMMAC-T.
1.5 BRIDGING/ROUTING CAPABILITIES
A slot on the back panel of the unit provides installation access for BRIMs
to the hub. MicroMMAC-T management systems treat the installed BRIM
and the hub as a single entity. Cabletron offers the BRIMs listed in
Table 1-3.
REAR VIEW
MicroMMAC Managing 4 Non-Intelligent Hubs
HubSTACK
STH-24
MicroMMAC-24T TOKEN RING HUB WITH LANVIEW®
BRIM Slot
STACK RESERVED
STACK5 STACK4 STACK3 STACK2
STACK RESERVED
RESERVED STACK
STACK RESERVED
HubSTACK
STH-24
HubSTACK
STH-24
HubSTACK
STH-24