Cabletron Systems MicroMMAC 24T MICROMMAC- - Manual (Page 68)

LOCAL MANAGEMENT
4-14
2. Toggle between ENABLED and DISABLED to make your selection.
3. Highlight the SAVE command and then press the Return key.
The “SAVE” message appears on the screen indicating that your
selection was saved to memory and the new value of the field takes
effect.
To set the Number of Retries field:
1. Highlight the Number of Retries field and type in an allowed value.
2. Highlight the SAVE command and then press the Return key.
The “SAVE” message appears on the screen indicating that your
selection was saved to memory and the new value of the field takes
effect.
To set the Retry Interval field:
1. Highlight the Retry Interval field and type in an allowed value (in
increments of 7 only).
2. Highlight the SAVE command and then press the Return key.
The “SAVE” message appears on the screen indicating that your
selection was saved to memory and the new value of the field takes
effect.
Setting COM 1 and COM 2 Applications
You can select COM port settings for LM, SLIP, UPS, Telnet, or a modem.
1. Highlight the COM port field and toggle to selection.
2. Highlight the SAVE command and then press the Return key.
The “SAVE” message appears on the screen indicating that your
selection was saved to memory and the new value of the field takes
effect.
4.3.3 The SNMP COMMUNITY NAMES Screen
Use the SNMP COMMUNITY NAMES (Figure 4-6) screen to establish
SNMP community names for the MicroMMAC-T. Community names