SunBriteTV SB-6560HD - Manual (Page 14)

Page 14 Page 14
TV Installation – Rear Panel Connection Diagrams
CONNECTING TO A SATELLITE OR CABLE SET-TOP BOX
1. 1. Make sure the power of the TV and your set-top box
is turned off.
2. Connect a HDMI cable to the HDMI output of your set-top
box and the other end to the HDMI port off the back of
your TV.
3. Turn on the TV and your set-top box.
4. Use the remote control’s source button or the source
button on the right side of the TV to switch to HDMI 1.
Please Note :
1. Refer to the set-top box’s manual, to make sure the set-
top box is configured to output correctly to the TV.
2. If HDMI 1 is already occupied, use HDMI 1 as your
connection port and switch source to HDMI 2.
3. SunBriteTV’s MODEL 6560HD supports SONY’s universal
remote code. Please look up SONY’s codes in your
universal remote’s hand book.
4. This TV will turn off automatically if there’s no signal
present for more than 15 minutes.
1. Make sure the power of TV and your set-top box is turned off.
2. Obtain a Component Cable. Connect the green color
connector to both your set-top box and Component 1’s green
connector port off the back of your TV.
3. Connect the blue color connector to both your set-top box and
Component 1’s blue connector port off the back of your TV.
4. Connect the red color connector to both your set-top box and
Component 1’s red connector port off the back of your TV.
5. Obtain a RCA Audio Cable. Connect the white color connector
to both your set-top box and Component 1’s white connector
port off the back of your TV to the right side of your green,
blue, red component connection.
6. Connect the red color connector to both your set-top box and
Component 1’s red connector port off the back of your TV to
the right side of your green, blue, red component connection.
7. Turn on the TV and your set-top box.
8. Use the remote control’s source button or the source button
on the TV to switch to YPbPr1.
Please Note :
1. If Component 1 is already occupied, please use Component 2
is your connection port and switch to source YPbPr2.
2. Please refer to the set-top box’s manual to make sure the set-
top box is configured to output correctly to the TV.
3. SunBriteTV’s MODEL 6560HD supports SONY’s universal
remote code. Please look up SONY’s codes in your universal
remote’s hand book.
4. This TV will turn off automatically if there’s no signal present
for more than 15 minutes.
Connecting with HDMI (Best)
Connecting with
Component (Better)