SunBriteTV SB-6560HD - Manual (Page 17)

SunBriteTV Model SB-6560HD Operator’s Manual Page 17
TV Installation – Rear Panel Connection Diagrams
Connecting with RCA Audio Analog (Good) 1. Make sure the power of the TV and your PC is turned off.
2. Obtain a 15-pin D-Sub VGA cable, connect to the VGA output of
your PC and the other end to the VGA port off the back of your
TV.
3. Obtain a 3.5 mm Mini-jack, connect to the audio out of your PC
and the other end to the VGA Stereo Input port.
4. Turn on the power of the TV and your PC.
5. Use the remote control’s source button or the source button the
TV to switch to VGA.
Please Note :
1. For the best results, please set your PC resolution to
2. 1920 x 1080at 60 Hz. Refer to the PC or graphic card’s manual
for further instructions on how to set your resolution and refresh
rate.
3. Refer to your PC manual for video output requirements of the
video card.
4. The VGA port of the TV features a power saving mode which will
automatically turn off the TV if there is no signal provided for
more than 15 minutes.
CONNECTING TO A PC (Continued)