Care of sunbritetv caring for the lcd panel, Cleaning the lcd panel – SunBriteTV SB-6560HD User Manual

Page 32

Advertising
background image

Page 32

Care of SunBriteTV

Caring for the LCD Panel

1. Cleaning the LCD Panel:

With your TV turned off , gently wipe the surface of the display panel with a damp (with water) microfi ber, cotton or fl annel

cloth. (Do not use tissues, rags, sponges or paper towels because they may damage the screen and leave lint pieces behind).
If the LCD panel is very dirty, you can mix equal parts of isopropyl alcohol and distilled water in a clean spray bottle, spray the

mixture onto the cloth (do not spray the solution directly on the panel) and gently clean the panel.
A “special outdoor formula” LCD Cleaning Kit is now available and can be ordered from SunBriteTV.

2. When the TV is not in use, keep it covered with the SunBriteTV Outdoor Dust Cover

The fi tted dust cover is constructed with weatherproof 4-ply polypropylene UV protection fabric that protects the window

from direct and indirect sunlight, and keeps wind-blown objects from scratching the surface of the window.
To order a SunBriteTV LCD Cleaning Kit or Replacement Outdoor Dust Cover, contact your Authorized SunBriteTV dealer,

SunBriteTV’s Customer Care Center at 800.331.4626, or visit www.sunbritetv.com.

General TV Cleaning

Remove any dirt and salt deposits from the unit, being careful to rinse the cloth frequently to avoid scratching the TV or screen

surface. Avoid using harsh chemicals, abrasives, or solvents when cleaning any surface on the unit.
Snow and Ice

Use a soft brush and towel to remove snow and ice from the unit.

Fiber Filter

Over time, the fi ber fi lter collects dirt and must be cleaned or replaced.
The Fiber Filter is located on the back of the unit, inside the Intake Vent at the top of the TV (Figure 1).
1. Release the Fiber Filter by pulling it out from the corner of the Intake Vent (Figure 2). Notice how the Fiber Filter fi ts in the upper

and lower channels, and tightly against the side.

2. Pull the Fiber fi lter out of the TV, and wash it with mild detergent and warm water. After rinsing, let the Fiber Filter dry completely.
3. Put the Fiber Filter back up into the Intake Vent pushing the fi lter fi rst into the upper channel, then fi t it into the lower channel.

Make sure fi lter fi ts tightly against the side. (Figure 3).

CAUTION! NEVER SPRAY OR DIRECT A HOSE INTO THE VENT AREA OF THE TV.
To Order Replacement Filters,
contact SunBriteTV’s Customer Care Center at 800.331.4626.

Figure 1

Figure 3

Fiber Filter

Intake Vent

Fiber
Filter

Figure 2

Advertising