Clevo M860TU - Manual (Page 32)

Disassembly
2 - 6 Removing the Hard Disk Drive
2.Disassembly
Removing the Hard Disk Drive
The hard disk drive is mounted in a removable case and can be taken out to accommodate other 2.5" serial (SATA) hard
disk drives with a height of 9.5mm (h). Follow your operating system’s installation instructions, and install all necessary
drivers and utilities (as outlined in Chapter 4 of the User’s Manual) when setting up a new hard disk.
Hard Disk Upgrade Process
1. Turn off the computer, and turn it over and remove the battery ( page 2 - 5 ).
2. Locate the component bay cover and remove screws - .
3. Carefully (a fan and cable are attached to the under side of the cover) lift up the bay cover .
4. Carefully disconnect the fan cable , and remove the cover .
5. The hard disk assembly cover will be visible at point on the mainboard.
Figure 2
HDD Assembly
Removal
a. Remove the screws.
b. Remove the cover and lo-
cate the hdd.

8. Component Bay
Cover
• 7 Screws

Fan Cable
Make sure you recon-
nect the fan cable
before screwing down
the bay cover.
9
1 7
8
9 8
10
a. b.
8
1 3 2
4
5
6 7
9
9
10