Sure Heat AGA Vented Dual AGA - Manual (Page 2)

- Due to high temperatures, the appliance should be located out of traffic and away from furniture and
draperies.
- Do not place clothing or other flammable material on or near the appliance.
- Children and adults should be alerted to the hazards of high surface temperature and should stay away to
avoid burns or clothing ignition.
- Young children should be carefully supervised when they are in the same room with the appliance.
- Please retain this manual for future reference.
The installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas
Code ANSI Z223.1, latest edition.
This appliance must be installed only in a solid fuel fireplace with a working flue and constructed of noncom-
bustible material.
Installation and repair should be done by a qualified service person.
The appliance should be inspected before use and at least annually by a qualified service person. More fre-
quent cleaning may be necessary due to excessive dust or carpet lint. It is important that the circulating air
passageways be kept clean.
Keep appliance clear and free from combustible materials, gasoline and other flammable vapors and liquids.
IMPORTANT INFORMATION
Fireplace Sizing Guide:
Set Size
18”
24”
30”
Opening
Height
16 1/2”
18”
20”
Front
Width
28”
32”
36”
Fireplace
Depth
15”
15”
15”
Chimney
Opening
50 sq. in.
50 sq. in.
50 sq. in.
The minimum opening that must be provided by the fireplace chimney to vent the unit properly is shown above
in the sizing chart.
It is necessary to provide adequate combustion and ventilation air. Air for combustion and ventilation must not
be obstructed. Provide adequate clearance around air opening in the combustion chamber and adequate
accessibility clearance for servicing and proper operation.
NEVER obstruct the front opening of the fireplace.
WARNING: Any safety guard removed for servicing an appliance must be replaced before operating the appliance
INSTALLATION
Unpacking
Unpack the appliance carefully and inspect for missing parts or damages that may have occurred during
shipping. If any part of the appliance is missing or damaged, please notify Sure Heat Manufacturing at
(770) 422-8008.
Fireplace Preparation
The fireplace needs to be properly prepared before installing this fireplace unit.
1. Turn off gas supply to the fireplace.
2. Clean chimney and fireplace floor of any combustible material to limit the smell from the system.
Gas Piping and Gas Pressure Requirements
PREPARATION
Check the type of gas that is supplied to your fireplace. Only install the unit that is equipped to operate on the gas
that is supplied to your fireplace. All gas piping must be installed to comply with local and national fuel gas codes.
Compounds used on threaded joints of gas piping must be resistant to the action of L.P. gas. Before installing the
Page 2
Rear
Width
21”
24”
28”