Sure Heat AGA Vented Dual AGA - Manual (Page 6)

Connecting Gas Supply to Burner Pan
1. Place burner system in proper location.
2. Attach brass 3/8” to 1/2” gas inlet fitting to the 1/2” gas supply stub.
3. Carefully bend the flared tubing as needed to make the connection between the burner assembly and the
gas inlet fitting. Next attach the flared tubing to the burner assembly first, then to the gas inlet fitting.
Avoid kinking the flared tubing while bending. If tubing must be cut, use a tube cutter. Flare the cut end of
the tube with a flaring tube.
Page 6
Burner System Location
1. The Burner system should be located towards the back and centered in the combustion chamber of the
vented fireplace. The burner system should be centered from left to right, with about an inch of space on
either side.