Sure Heat Sonoma SGR27 Natural Gas Conversion Kit - Manual (Page 2)

Be sure gas supply is off, the knobs are in the off
position and the grill is cool.
1. Remove cooking grates and flavor grids.
(See Fig. 1)
2. Remove the screws holding the rear heat shield
in place. Lift out rear heat shield and set aside.
(See Fig. 2)
3. Remove the two screws holding each igniter in
place. (See Fig. 3)
4. Lay igniters on floor of grill. (See Fig. 4)
5. Loosen the four (4) screws from the bottom of the
heat shield, holding the front heat shield in place.
The screws are located under the bottom lip of
the shield.
(See Fig. 5)
6. Loosen the two (2) side heat shield screws
located under the bottom lip of the heat shield.
There is one screw on each side. (See Fig. 6)
2
Tools Needed:
Phillips head screwdriver
1/4” nut driver *
Adjustable wrench
Fig 4
Fig 1
Fig 2
Fig 3
SGR27 Natural Gas Conversion Instructions
Rear Heat Shield
Igniter Heat Shield
Screws
Flavor Grids
Screws
* 1/4” socket set with extension can also be used.
Fig 5
Fig 6
Side Screw
(Repeat on left side)
Screws
under lip