Sure Heat Sonoma SGR27 Natural Gas Conversion Kit - Manual (Page 4)

You are now ready to install
the new NG manifold.
15. Start by placing the new manifold into the grill
body with the control knob stems going outward
through control panel front. (See Fig. 14)
16. Reattach the flex line on the right of the grill to
the new manifold using the adjustable wrench.
(See Fig. 12 on previous page)
17. Reattach the bezels to the manifold with the
two (2) screws removed in Step 13. Make sure
that “off” is facing up on the bezel.
(See Fig. 10 & 11)
18. Reattach the control knobs onto the manifold
stems, making sure the arrow is facing upwards.
(See Fig. 9 on previous page)
19. Reinstall burners into the grill body. Line up the
burners with the valves on the manifold, making
sure they are level. (See Fig. 15 & 16)
20. Reattach the igniters and their heat shields,
removed in Step Four (4), to the burners.
(See Fig. 3, on page 2)
21. Reattach the rear heat shield before attaching
the front heat shield to be sure the burners
remain over the valves. (See Fig. 17)
22. At this point of the conversion, a leak test should
be performed on all fittings. See Use and Care
manual for leak testing procedure.
23. Proceed with reattaching the front heat shield.
(See Fig. 5 and 6 on page 2, and Fig 7 on
previous page)
24. Reinstall the flavor grids.
(See Fig. 1 on page 2)
25. Reinstall the cooking grates
4
Fig 14
Fig 15
Fig 16
Fig 17
Burners fully
over valves
SGR27 Natural Gas Conversion Instructions
Valves
Burners
Rear Heat Shield
Control Knob
Stems