Sure Heat Sonoma SGR27 Natural Gas Conversion Kit - Manual (Page 6)

5. Attach the 3/8” to flared fitting to the “T” fitting as
shown. Remember to apply pipe dope to the
non-flared end. Tighten with wrench.
(See Fig. 22)
6. Attach the 3/8” street elbow to the bottom of the
“T” connector (See Fig. 23)
7. Attach the 3/8" nipple to the 3/8" street elbow.
(See Fig. 24)
8. Attach the NG regulator to the nipple
(See Fig. 25).
Note: pay attention to arrow on the NG
regulator indicating direction of gas flow.
The arrow should point toward the grill.
Remember to apply pipe dope!
9. Attach one end of the supplied hose to the flared
fitting on the side of the “T” connector.
(See Fig. 26)
The other end of the hose will be attached to the
side burner later.
10. Replace the grommet in the side of the cart by
pressing with your fingers.
(See Fig. 27)
This completes the NG regulator installation.
6
SGR27 Natural Gas Conversion Instructions
Fig 23
Fig 24
3/8” To
Flare
Fitting
Fig 22
Street
Elbow
Fig 25
Fig 26
Fig 27