SUUNTO t3 - Manual (Page 42)

NOTE Even though both the Suunto t3 and the transmitter belt are water-resistant,
the radio signal does not carry in water, which makes the communication
between Suunto t3 and the transmitter belt impossible.
7.3. Changing the strap length
The strap length of some Suunto t3 models can be adjusted for a perfect fit. Follow the steps below:
• Remove the buckle by releasing the spring bars with a pin, paper clip or other sharp object.
• Remove both spring bars from the pin holes.
• Shorten the strap by cutting along the grooves on the inner surface. You can do this for instance
with scissors. If you are unsure of the correct length, cut the pieces one by one and test the
length after cutting each piece. Cut in turns from both sides of the strap to keep the sides
equally long. Be careful not to shorten the strap too much.
• Replace the spring bars into the last pin holes of both sides of the strap.
• Attach the buckle to the strap by placing the spring bars into the holes in the strap. In both
sides of the buckle are holes for two different positions. This can be used for fine tuning of the
strap length. Make sure that the spring bars are positioned straight in the buckle.
40