SUUNTO Zoop - Manual (Page 82)

80
BATTERY REPLACEMENT
The battery and the buzzer are located in the back of the instrument in a separate
compartment, the parts of which are shown in Fig. 5.1. To change the battery, follow
the procedure below:
1. Remove the computer from the console or boot.
Wrist model:
• Disassemble the shorter part of the strap with a flat 1.5 mm screwdriver or a
special tool for spring bars. The longer part of the strap may stay on but removing
it may ease the work later on.
Console model:
1. Remove the dive computer from the console according the instructions of the
console.
2. Thoroughly rinse and dry the computer.
3. Open the securing ring of the battery compartment lid by pushing it down and
rotating it clockwise. You may use a pointed nose pliers or a small screwdriver
as an aid in the rotating. Put the pliers ends into the holes of the securing ring or
the screwdriver onto the side of the right tooth on the ring (Fig. 5.2) and turn the
ring clockwise. Care should be taken not to damage any of the parts.
4. Remove the ring.
5. Carefully remove the lid with the beeper attached to it. The lid can be removed
by pressing with your finger on the outermost edge of the lid while at the same
time pulling with your nail at the opposite side. Do not use sharp metal objects
as they might damage the O-ring or the sealing surfaces.