TechniSat DVB-T/IP IRD - Manual (Page 48)

48
EN
IP Output Description value
Type of Service
TOS is used for priorizing IP – data
packages
Normal, MIN DELAY,
MAX THROUPUT, MAX
RELIABILITY, MIN
MONATARY COST
Mode
Selecition of the playout mode: DVB
MODE (MPTS) or IPTV (SPTS). After
click to the button Uni/Multicast Setup
the setup window is opening.
DVB, IPTV
Stream IP IP-Address TS/IP interface
Stream Netmask
Subnet mask for the Subnetwork to
which the IP/TV interface is connected.
Stream Gateway
Gateway for the network with to the
IP/TV Interface is connected
Stream MAC
Address
Factory site MAC Address for the TS/IP
Interface, this can only be used once and
not be changed.
Gateway MAC
Address
MAC Address of the Gateways for the
Network to which TS/IP Interface is
connected
Save the value with a click to the Apply button.
4.6.5.1 Uni-/Multicast play out
The data transmission can be in Unicast or Multicast.
The data transmission can be Unicast or Multicast.
Unicast
In case of unicast-transmission the data will be transferred from one point to one receptor.
Multicast
In case of Multicast transmission, the data will be transferred from many points to many
receptors simultaneously, without multiplying the data volume by the number of receptors.
This is possible due to a special multicast address within the range from 224.0.0.0. to
239.255.255.255 with using of the IGMP protocol. Details for the multicast address can be also
found in RFC5771.
Mode
There are two different ways of transmitting the programs into the IP-Network:
⇒ in DVB Mode as SPTS
⇒ in IPTV Mode as MPTS