TeeJet CenterLine v1.07 - Manual (Page 42)

36 CenterLine
CenterLine Real-Time Operation
CenterLine
Software Version 1.07
Return to Point
CenterLine allows the operator to mark a point in the field to return to later in time. Typi-
cally the Return to Point feature is used to mark a location when stopping guidance and
wanting to start in the same location and in the same direction at a later time. This Return
to Point location is stored with the field’s trajectory data, is lost when <NEW?> is selected,
and retained when <RESUME?> is selected.
There is a specific Return to Point key located on the wireless remote, see Figure 4. This key
works in toggle fashion; press it once to mark the point (the lightbar displays <!"#>), press it
again to navigate back to the point. Stop the navigation process by pressing ESC. When Return
to Point is pressed again (third time) the old location is replaced with the current vehicle location.
While operating in the Return to Point mode, no active text messages are displayed except error
messages. If the vehicle enters an area that has already been applied, the display alternates
between the Return To Point distance and <Applied!>.
Exiting Real-time Operation
To exit guidance, press Esc or scroll with Up or Down in the real-time menu until <EXIT?> is dis-
played (Figure 35) in the text window and Press Enter. <BYE> appears in the text window, real-
time operation stops, and the display returns to the main menu.
Figure 35: Exit in Display