TeeJet FieldPilot Install John Deere 8x20 - Manual (Page 16)

14
www.teejet.com
FieldPilot ®
9. install the ValVe control caBle
The valve cable exits the cab through an access plate with knockouts in the left rear section. Connect the
FieldPilot valve control cable (E) to the FieldPilot valve by attaching the DIN connectors to the individual coils. Do
not be concerned at this time about which connector is connected to which solenoid coil. Route the cable along
the front underside of the cab and around the right side to the access panel. Secure with tie wraps as necessary.
NOTE: If the vehicle steers the wrong way when it is tested, exchange the connector positions.
NOTE: After all cables and wires have been wired into the cab, ensure the knockout is resealed.
Figure 1-14: Install Valve Control Cable