TeeJet FieldPilot Install Miller Condor - Manual (Page 11)

9
FieldPilot ®
98-05160 R2
1. PrePare the FieldPilot ValVe
Install adapter (R) in the A, B, and T ports of the FieldPilot valve (C) . Install adapters (S) on adapters (R) in the
A and B ports. Install adapter (Q) in the EF port. Install adapter (P) in the P port.
Figure 1-4: Prepare the FieldPilot Valve
2. PrePare the ValVe Bracket
Locate the front right cab support beam. Using the top of the two pre-drilled holes on the front edge of this support
beam, install bracket (I) as shown using bolt (G) , two washers (B) , and nut (H) .
Figure 1-5: Prepare the FieldPilot Valve Bracket
i
G, B
& H
R
R
s
R
s
Q
p