Vermont Casting IRHEDV32 - Manual (Page 17)

10003929
A-TRIM OPTIONS FOR RHEDV32
17
FRAME ASSEMBLY
1. Lay Trim Top Facing and Trim Side Facings, face down
on to an even surface such as a table or floor. Be sure
not to scratch the painted surfaces.
2. Install the nuts and bolts (Fig. 21).
Fig. 21
A1) RHESS, RHESL, RHESSD, RHESLD & RHESXL TRIMS
RHESS, RHESL, RHESSD, RHESLD and RHESXL
TRIM ASSEMBLY
1. Install trim channels (left and right sides). Use two
screws to assemble each piece.
2. Slide on the trim top channel and fasten it from the back
side.
3. Install the trim top deflector and use two screws to fasten
it. (Fig. 22 & 23)
4. Remove ALL plastic protective covering from brass trim.
Fig. 22
RHESS, RHESL, and RHESXL (Fig. 22)
1. Install trim channels (left and right sides). Use two
screws to assemble each piece.
2. Peel off plastic protective covering from top edges of
the inner sides where they will be covered by the inner
top trim facing.
3. Place the trim facing inner top in place (do not fasten it
yet). Peel off the plastic protective covering from the
bottom edge.
4. Install the trim top deflector and fasten it (will hold the
inner top piece). Use two screws to assemble them.
5. Install trim channels (left and right sides). Use two
screws to assemble each piece.
6. Slide on the trim top channel and fasten it from the back
side.
7. Remove ALL plastic protective covering from brass
trim.
RHESSD and RHESLD (Fig. 24)
A flat louvre kit OR a bay window kit
needs to be chosen to complete the
installation.
Fig. 24
Fig. 24
LEFT
FRAME RIGHT
FRAME
FRAME TOP
10/24
NUTS
10/24
SCREWS
FIG.1
AS SHOWN FROM BACK
Side View
Trim Frame Top Section
Trim Top Deflector
TRIM SIDE
CHANNEL TRIM SIDE
CHANNEL
TRIM TOP CHANNEL
SCREW
DEFLECTOR
TRIM TOP
AS SHOWN FROM FRONT
TRIM SIDE
CHANNEL
TRIM SIDE
CHANNEL
TRIM TOP CHANNEL
SCREW
DEFLECTOR
TRIM TOP
AS SHOWN FROM FRONT
TRIM FRAMING
INNER TOP
TRIM FRAMING
INNER SIDES
IMPORTANT: Only Trim Panel Assemblies approved by Vermont Castings Majestic Products Company can be used.