Toa S-20S Ver.5.0 User Manual
Page 10
10
[Control]
The connected Sound Repeater can be remotely
operated by the PC. Displayed buttons differ
according to the Repeater model connected.
(6) PLAy
Plays back selected audio data.
(7) REC (except the EV-20S and S-20S)
Activates the Sound Repeater to make recording
into the selected audio data area. (Refer to
.)
(8) STOP
Stops playback or recording.
(9) Format
Formats the memory or the SmartMedia card
mounted in the Sound Repeater or deletes its
stored data all at once. The SmartMedia card is
formatted exclusively for the Sound Repeater.
Format the card once before using a commercial
SmartMedia card with the Sound Repeater first.
(10) Start (EV-20A only)
Click this button to activate the EV-20A after
making settings or read/write operations on this
software program. (Refer to
.)
Note
Leave the EV-20A's Record/Play Selector Switch
in the right position (playback mode) in advance.
(11) Audio data selection area
The selection buttons differ according to the
connected Repeater model as follows:
• EV20R, EV-20S, and S-20S:
No.1 – 4
• PM-20EV:
Announce, CHIME A, and CHIME B
• EV-20A:
MESSAGE A, MESSAGE B, BGM A, and
BGM B
Three or four sets of audio data can be written
into the audio data area. Click the data selection
button to select the corresponding audio data to
handle.
If no Sound Repeater is connected to the PC,
the four selection buttons appear indicated as
No.1 to No.4. The number of the buttons and
their names depend on the connected Sound
Repeater model. The screen on the previous
page is an example when the Repeater model
is EV-20A.
(12) Initialize Media (EV-20A only)
The SmartMedia card supplied with the EV-20A
or formatted by the Format button (9) can be
used only for the EV-20A. Clicking this button
initializes the SmartMedia card mounted in the
EV-20A to apply to PCs and digital cameras.
[Memory Buttons]
Enable the writing or deletion of individual audio data.
(13) Read
Saves selected audio data recorded on the
Sound Repeater to the PC.
(14) Write
Writes audio data stored in the PC to the selected
audio data area in the Sound Repeater.
(15) Clear
Deletes selected audio data recorded on the
Sound Repeater.
(16) Refresh
Recalls and displays (on the Sound Repeater
Memory area) the filenames and information of
all audio data recorded on the Sound Repeater.
(17) Connect
When changing the connection between the
PC and the Sound Repeater while using this
software program, click the Connect button to
reestablish the connection.
[Audio data Information]
Displays relevant Sound Repeater data.
(18) Filename
Displays the filename of the audio data.
(19) Size (KByte)
Displays audio file size in kilobytes.
(20) Size (Sec)
Displays audio file length in seconds.
(21) Comment
Displays comments about the audio data.
(22) Interval
Displays the repeat playback interval between
audio data.
(23) Free space
Indicates the remaining memory capacity of the
Sound Repeater's internal memory or installed
SmartMedia card.
Note
The indicated capacity is approximate for your
reference. Actual capacity may be smaller than
it.