Toa S-20S Ver.5.0 - Manual (Page 12)

12
[Information]
Data regarding the project can be entered and stored.
(24) Project name
The name of the project is entered and displayed.
Up to 128 characters can be entered.
Note
As the project name becomes the folder name,
do not enter any characters that cannot be used
for the folder name.
(25) Creator
The name of the creator is entered and displayed.
Up to 128 characters can be entered. All types of
characters can be used for entry.
(26) Explanation
Explanatory information about the project is
entered and displayed. Up to 256 characters can
be entered. All types of characters can be used
for entry.
(27) Model
Displays and selects the Sound Repeater model
number to be used.
[Memory Buttons]
Permit editing of Sound Repeater audio data.
(28) Enter
Programs audio data to be written to the Sound
Repeater.
(29) Delete
Deletes selected programmed audio data.
(30) Open
Reads and displays entire Repeater data (for
individual projects) stored in the PC.
(31) Save
Saves audio data and information being edited
to the PC as a file for entire Repeater data (for
individual projects).
(32) Link wave files
Creates new audio data by linking two audio files
stored in either the PC or the supplied CD-ROM.
[Programming Status]
Audio data used by the Sound Repeater can be
edited. Comments can also be added to each file.
(33) Filename
Displays the filename of the audio data.
(34) Size (KByte)
Displays the audio file size in kilobytes.
(35) Size (Sec)
Displays the audio file length in seconds.
(36) Free space
Indicates the remaining memory capacity
of the Sound Repeater's internal memory or
SmartMedia card.
Note
The indicated capacity is approximate for your
reference. Actual capacity may be smaller than
it.
(37) Comment
Used to display and enter comments about the
audio data. Up to 128 characters can be entered.
All types of characters can be used for entry.
(38) Interval
Sets the repeat playback interval between audio
data. Select the desired interval from the pull-
down menu. When the Sound Repeater has a
switch to set the interval, the interval cannot
be set on this screen. In this case, use the
Repeater's interval setting switch.
(39) SmartMedia capacity (EV-20A only)
Select the memory capacity of the SmartMedia
card to be used for the Sound Repeater.
[Miscellaneous]
(40) One-Touch Write [<<] (Center-left of the area
screen)
Writes data contents programmed on the Sound
Repeater's PC Hard Disk area by transferring
them to the Repeater. Written contents are
displayed on the Sound Repeater Memory area.
(41) Backup [>>] (Center-left of the area screen)
Displays the Sound Repeater's recorded
contents by transferring them to the PC Hard
Disk area.
(42) End (Top right of the area screen)
Quits and exits the software program.
Selecting [File → Exit] on the toolbar menu also
performs this operation.