Toa S-20S Ver.4.01 - Manual (Page 5)

5
5. SOFTWARE PROGRAM INSTALLATION
To use the USB function, install the software programs in the PC.
Two software programs need to be installed: The USB driver and data transfer software programs.
Notes
• Before operating, confirm the CD-ROM drive letter (such as E or F) of the PC to be used. The drive letter is
displayed near the CD-ROM icon in "My Computer."
• You need not install the USB driver program if the different version of the data transfer software program has
already been installed in the PC.
5.1. USB Driver Installation
Step 1. Start the PC.
Step 2. Insert the supplied CD-ROM into the PC's CD-ROM drive.
Step 3. Check to be sure that the Sound Repeater's power is switched OFF.
Step 4. Using the supplied USB cable, connect the Repeater's USB terminal to the USB terminal of the PC or
USB hub.
Step 5. Switch on the Repeater's power.
The following screen is displayed on the PC screen.
A few seconds later, the following screen is displayed.
After another few seconds, the following screen is displayed.