Toa C-PH200 - Manual (Page 4)

4
When Installing the Pan/Tilt Head
• Use nuts and bolts that are appropriate for the ceiling’s or wall’s structure and composition. Failure to do so
may cause the unit to fall, resulting in personal injury.
• Tighten each nut and bolt securely. Ensure that there are no loose joints after installation to prevent
accidents that could result in personal injury.
• Use the specified type of camera housing and wall mounting bracket. If the unit is installed in combination
with equipment not specified, the unit may fall, possibly resulting in personal injury.
• Avoid installing the unit in locations exposed to sea breeze or corrosive gas. The unit or its mount may be
subject to corrosion, which could cause the unit to fall, possibly resulting in personal injury.
• NEVER operate the Remote Controller while somebody is handling the pan/tilt head. Fingers can be caught
in the moving pan/tilt head mechanism, possibly resulting in personal injury.
When Using the Pan/Tile Head
• Should the following irregularities be found during use, immediately switch off the power, disconnect the
power supply plug from the AC outlet and contact your nearest TOA dealer. Do not attempt to further
operate the unit to avoid fire or electric shock.
• If you detect smoke or a strange smell coming from the unit.
• If water or other foreign objects get into the unit.
• If the unit falls, or the unit case breaks.
• If the power supply cord is damaged (exposure of the core, disconnection, etc.)[Remove a power
supply cord.]
• Do not open the unit’s case for modification. Since there are high voltage components inside the unit,
opening or modifying the case may result in fire or electric shock. Refer all servicing to your TOA dealer.
Indicates a potentially hazardous situation which could result in death
or serious personal injury if ignored or mishandled. WARNING
Indicates a potentially hazardous situation which could result in
moderate or minor personal injury, and/or property damage if ignored
or mishandled.
CAUTION
When Installing the Pan/Tilt Head
• Notes on Housing Cable Connections
Be sure to observe the following precautions. Failure to do so could cause damage to the cable when the
pan/tilt head rotates, possibly causing a fire.
• Fix the housing cable securely with a cable clamp to prevent its contact with other parts and
components.
• Fix the housing cable so that extreme force is not applied to the cable when the pan/tilt head rotates in
the vertical direction.