Triner Scale T-1000 TELESET - Manual (Page 18)

31 30
Operator manual T-1000 TELESET TELESET postage resetting
3. The last amount used to reset your meter
will appear in the display ($ 200.00 in the
example).
4. To reset the amount displayed, simply
press the ‘TELESET’ key.
5. The word ‘Reset’ and the amount being
reset will alternately appear in the
display while the process is handled
automatically. The entire process should
take less than one minute. When complete
the T-1000 will return to the ready mode.
Note:
If a problem occurs look at section 9.2.
RESETTING A NEW AMOUNT
1. Make sure the meter is switched on and
connected to the phone outlet.
2. Type in your 8 digit PIN, (‘12345678’ in the
example) as shown on your meter ID card.
Confirm it with the white ‘TELESET’ key.
You are now in the TELESET mode.
3. The last amount used to reset your meter
will appear in the display ($ 300.00 in the
example). Now you have the option to
reset the meter with a new amount of
postage. To do so, simply enter the new
amount instead of pressing the white
‘TELESET’ key. Be sure to enter the
amount in multiples of ten dollars and the
new reset amount will appear in the
display.
4. Confirm the new amount by pressing the
‘TELESET’ key.
5. The word ‘Change’ and the new preset
amount will alternately appear in the
display. The T-1000 automatically
connects to the TELESET system.
When it’s ready to reset, the word ‘Reset’
and the amount being reset will appear
alternately in the display.
6. Within 30 seconds press the white
‘TELESET’ key again to confirm reset of
the new amount. The display will count
down from 30 to remind you. The process
is then handled automatically. When
complete the T-1000 will return to the
ready mode.
Note: If an incorrect entry is made while in the
TELESET mode, you can clear it with the ‘C’
key. To exit the TELESET mode completely,
press the ‘C’ key a second time.