CLIFFORD RSX3.2 - Manual (Page 21)

18 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d
➤ Press a fourth time within five seconds: The siren chirps four
times followed by a long chirp. Zones 2 and 4 are now bypassed.
➤ Press a fifth time within five seconds: The siren chirps
five times followed by a long chirp. All input zones, except
the ignition, are now bypassed.
After each press of the to reach the next level of security, the
remote will emit normal arm notification (1 beep and 3 flashes of
the Orange LED). For easiest operation in reaching each level of
security, press immediately aafftteerr each notification.
arming while driving
Your security system can be armed while driving the vehicle!
Simply press on the 2-way remote for two seconds while the
vehicle is running. The siren will chirp once to indicate that the
security system is armed, and then once more to indicate that the
ignition is on. The system will not respond to any input except the
door triggers, and the starter kill relay (if installed) will not be acti-
vated. Once you have arrived at your destination, the system can
be disarmed by pressing the or by turning the ignition Off.
The siren will chirp twice and the in-vehicle status LED will then
stop flashing. The system can also be disarmed at any time by
pressing ..
➜
note: Multi-Level Security Arming only applies to a sin-
gle arming cycle. Once the system is disarmed and then
re-armed, all the zones will be active again.