CLIFFORD RSX3.2 - Manual (Page 27)

24 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d
fan blower must be set to the desired level prior to remote starting
the vehicle.
To remote start the vehicle:
1. Press on the 2-way remote twice within 3 seconds.
2. The parking lights will flash to confirm that the vehicle will
attempt to start.
3. In gasoline vehicles, the engine will start 4 seconds after the
parking lights flash. In diesel vehicles, the engine will start
when the WAIT-TO-START indicator on the vehicle's dash
goes out or the programmed delay has ended.
4. Once the vehicle has started, it will run for the pre-program-
med period of time (either 12, 24, or 60 minutes - see
Programming Options section of this guide) or until a shut-
down input is triggered.
For a remote start, the remote responds with remote start tones
and the Yellow LED illuminates for 3-seconds.
For a remote start Off, the remote responds with remote start off
tones and the Yellow LED flashes 3-times.
iim mp poorrttaan ntt!! It is unsafe to operate a vehicle’s motor in a
garage or other closed off area. Breathing the exhaust
from the vehicle is hazardous to your health. Never acti-
vate the remote start in an enclosed space.
iim mp poorrttaan ntt!! (1) Never remote start your vehicle when the
keys are in the ignition, except when performing Valet ®
Take-Over, and (2) Never start the vehicle if it is not in
either PARK or NEUTRAL.