CLIFFORD RSX3.2 - Manual (Page 22)

19 © 2 0 0 5 d i r e c t e d e l e c t r o n i c s — a l l r i g h t s r e s e r v e d
The remote will respond with the normal arming response plus a
diagnostic notification because the ignition is On. When disarmed
the remote will respond with the normal disarming response.
disarming
To disarm the security system, press . You will hear two
chirps, and the parking lights will flash twice. If the power locks
are controlled by the system, the doors will also unlock. The siren
chirping either four or five times when disarming indicates
Tamper Alert, which is described in the Diagnostics Section of
this guide.
The remote will indicate disarm notification with 2 beeps and 3
flashes of the Orange LED. If disarming after the system has been
triggered, the remote control will send a diagnostic notification as
a reminder. These diagnostic notifications are:
1. If a sensor triggered the system, the remote will beep 4-times
and the Orange and Red LEDs flash 3 times.
2. If a switch (Zone 1, 3, 5, or 6) triggered the system, the
remote will beep 4-times, the Orange LED will flash 6-times
and Red LED will illuminate for 3 seconds.
3. If the system was triggered so many times that NPC is active
the remote will emit the above notifications with 5 beeps
instead of 4.
➜