TYREDOG TD-1400A-X4 - Manual (Page 41)

V1.0-FB06 (1105232) 41
A. Please make sure if sensors are in a configured distance. This
system, TD1400A-X, should be applied in passenger car. If installed
in other kind of vehicle, the system doesn’t guarantee its
functionality.
B. Please make sure if sensor has battery inserted.
C. Be sure to sensor the correct polarity when installing the batteries.
D. Battery has no power after use for a long time. Battery could run out
of power and we suggest to replace with new battery.
E. Please make sure if your sensor has mixed with other systems’. As
each sensor has its unique identified number and monitor can only
receive pre-loaded identified number and cannot accept other new
identified number.
F. Please re-install the sensor’s battery. After take away sensor’s
battery, the status of being without battery need to leave for 10
seconds and then insert battery again. It is for resetting system.
G. If these solutions do not help improve the situation, consult your
nearest Tyredog dealer.
3. Monitor have “Don” sound
When monitor screen have power is low ，if you continued use
maybe cause monitor function unusual phenomenon ,Just replace the
battery can bake to normal.
4. Monitor in the ‘standby mode’.
Temporarily park car or drive car in a stable speed, which could let
monitor get into ‘sleeping mode’. It is a special design for power-saving