USL CM-8E User Manual
Page 20
20
6.3
Configuration Screen
Click “Configure” at the bottom of the page. The system will ask for a username and password.
The username is “admin”, and the password is “ultra” (both lower case, no quotes). A page
similar to the image below should appear.
The right side of the page shows information about the CM-8E including the serial number,
circuit board revision, and firmware versions. There are two microcontrollers in the CM-8E,
identified as P24 and P32. The P24 does audio level measurement for the web bar graphs. The
P32 does everything else, including the web server. Each of these processors has a boot loader
that allows for field updates to the system. The version of the boot loader is also shown on this
screen.
This page allows you to set auditorium specific data that is saved in the CM-8E. The theater
name and screen number are shown on the web home page. After changing settings, click the
Save User Data button to save the data.
6.4
Network Configuration
Click the Network link on the third line of the page to get to the network configuration screen.
An image of that screen is shown below.