USL CM-8E - Manual (Page 4)

4
1.0 Safety Notice
Safety Notices
Review the following safety precautions to avoid injury and prevent damage to this product.
To avoid potential risk, use this product only as specified and only for the purpose described in
the instruction manual.
To Avoid Fire and Personal Injury:

Use correct power cable. Use only the power cable provided. Ensure that the AC power
outlet is located near the product and is easily accessible.

Use a correctly grounded power source. The power supply earth ground is established
through the ground conductor in the power cable. To avoid the potential of electric shock,
the ground conductor must be correct.

Observe source ratings. To avoid risk of fire or electric shock, the power source must be
100 – 240 VAC, 50 – 60 Hz.

Do not operate with suspected failures. If you suspect there is damage or malfunction
with this product, call the factory.

Do not attempt repair. Only a trained factory service person is authorized to repair this
product.

Do not operate this product near heat sources. This product should not be located near
heat sources such as radiators, heat registers, or stoves.

Provide proper ventilation. The operating temperature range is between 0º C and 40º C.
The humidity range is between 20% and 80%, non-condensing. The cooling method is
convection.

Keep product surfaces clean and dry. Disconnect the power cable from the power source
before cleaning. Do not use liquid cleaners or aerosol cleaners. Use a damp cloth for
cleaning.

Do not push objects into openings of this product. Never insert objects into the product
through openings.

Do not operate in wet or damp conditions.

Do not operate in an explosive atmosphere.

Inspect the power cable and all cables prior to use. Confirm that the power cable and
other interconnecting cables are free from damage.
2.0 Regulatory Compliance
EN 60950-1
The EN 60950-1 standard specifies the safety design requirements that reduce or eliminate the
risk of personal injury to both the product user and service personnel. This product is designed
and tested to meet the standards of the International Electrotechnical Commission (IEC)