Compaq 5532 - Manual (Page 153)

Configuration Through the Network with ARP
153
5. telnet to the Internal Ethernet Adapter. This will bring up a login
screen.
telnet ipname
6. Log on to the Print Server as root.
7. At the password prompt, press <Enter>. No password is required
at this point as the Internal Ethernet Adapter is still unconfigured.
NOTE: This WARNING message is normal at this point and should be
ignored:
STORED AND CURRENT VALUES DIFFER
You should now see a prompt displayed having the Internal
Ethernet Adapter followed by a colon, then root.
ipaddress:root>
8. Store the new IP address and netmask in EEPROM so the Internal
Ethernet Adapter remembers its configuration after rebooting.
Enter:
store tcpip ifnum addr ipaddress
store tcpip ifnum mask netmask
NOTE: ifnum is the index to a particular Network Interface. ifnum will
always be 1 for the Internal Ethernet Adapter.
9. [Optional, but recommended] Configure root and guest user
passwords with the following commands:
set user passwd root newrootpasswd
set user passwd guest newguestpasswd
10. Save these configurations to EEPROM. Enter:
save
11. Verify the IP address and netmask. Enter:
list stored tcpip
These are now stored in EEPROM.
12. Log out of the Telnet session with quit. Reboot the Internal
Ethernet Adapter by powering the unit off, then on.
13. Test the equipment and configuration after installation is complete.
Enter at the shell prompt on your UNIX machine:
ping ipname