VACUUBRAND VNC 1 - Manual (Page 15)

Documents are only to be used and distributed completely and unchanged. It is strictly the users´ responsibility to check
carefully the validity of this document with respect to his product. Manual-no.: 999118 / 16/12/2009
page 15 of 35
VACUULAN
V. 2.00
after 2 sec
Esc
Switch on
Menu structure of controller
Esc
Program menu
see section
”Working with the
controller”
”Program menus”
1013mbar
Start
↵ ↵↵ ↵↵
Start of program
within
2 sec within
2 sec
Device menu
see next page
• Readjustment
• RS 232 parameters
• Sound
• Units of pressure
• Auto start
• Language
• Time delay (not for VACUULAN)
• Control (only for RC 5/RC 6)
• External error input
Function menu
Function
Cont.pum
Function
pControl
Esc Esc
↵ ↵↵ ↵↵
Esc
only possible in ”vacuum control”
Notes on menu structure of the controller
Function menu:
•
Setting of the basic function of the controller (only in ”vacuum control” (pControl)).
Device menu:
•
Setting of the device specific features and the periphery of the controller.
- Readjustment: Adjusting the pressure transducer at atmospheric pressure and under vacuum, see
section ”Readjustment”.
- RS 232 parameters: Setting of the interface parameters, see section ”Interface parameters”.
- Sound: Switching on/off the function ”acoustic warning signal”.
- Pressure unit: Selection of the pressure unit mbar, Torr or hPa.
- Auto start: Process starts immediately after switching on the controller.
- Language: Selection of the language in the menus (English, German, French).
- Time delay: Delayed switching off of the cooling water and the pump (not for VACUULAN)
- Control: Control of a valve or a pump via the IEC control line (only for RC5/RC6).
- External error input: In case of failure of the signal the control sends an error message and switches off
the pump, if preset.
Attention: When operating a VARIO pump the external error input is used to indi-
cate a failure of the frequency converter and can not be wired externally.
Program menu:
•
Setting of the function specific parameters (e. g. preset pressure).
Attention: Depending on factory-set configurations some menu options are not active!
↵ ↵↵ ↵↵