Compaq LA36 - Manual (Page 79)

4-25
Using Set-Up Mode
Changing Install Options
The
INSTALL
function defines the printer’s installation conditions. You can select a
language from five that are used to print menu functions and options during the Set-Up
operation . You can adjust the start timing of auto loading or auto tear-off feeding. You can
also change the operation of the error beep or allocation of the input buffer. If you are using
the DEC-423 serial interface, you must set the serial interface options properly for the
printer to function correctly with your system hardware.
The following table describes the
INSTALL
options and values . Options are listed in the
order in which they are printed. For the procedure for changing the
INSTALL
options, see
the early sections of this chapter.
Install Options List
Language ............................................................................................................................ 4-26
Tear ..................................................................................................................................... 4-26
Single Sheet Load .............................................................................................................. 4-26
Error Beep .......................................................................................................................... 4-26
Buffer ................................................................................................................................. 4-27
Interface Type .................................................................................................................... 4-27
Auto Switch ....................................................................................................................... 4-27
Baud Rate ........................................................................................................................... 4-28
Bit & Parity ........................................................................................................................ 4-28
Buffer Control .................................................................................................................... 4-28
Disconnect on Fault ........................................................................................................... 4-28