Compaq LA36 - Manual (Page 99)

6-3
Trouble-Shooting
Problem Solution
The top margin is wrong. The top margin is the sum of the printer’s top-of-form
setting, the software-specified top margin, and the
printer’s
TOP-MRGN
setting. Proceed as follows:
• Make sure that the top-of-form setting is correct.
The factory default is 0 mm (0 inch). See the
section “Changing Top of Form Origin” in
Chapter 4, page 4-29.
• Check the software-specified top margin. Refer to
your software documentation.
• Check the printer’s
TOP-MRGN
setting. See the
section “Changing Macro1 and Macro2 Options”
in Chapter 4, page 4-18.
Check the line spacing setting in your software.
Change the
LINE MODE
setting in the printer Set-Up
mode to
LF=LFCR=CR
. See the section “Changing
Macro1 and Macro2 Options” in Chapter 4,
pages 4-18 and 4-19.
Change the
LINE MODE
setting in the printer Set-Up
mode to
CR=LF+CR
. See the section “Changing
Macro1 and Macro2 Options” in Chapter 4,
pages 4-18 and 4-19.
Change the
LINE MODE
setting in the printer Set-Up
mode to
LF=LF+CR
. See the section “Changing
Macro1 and Macro2 Options” in Chapter 4,
pages 4-18 and 4-19.
Change the
LINE MODE
setting in the printer Set-Up
mode to
LFCR=LF+CR
. See the section “Changing
Macro1 and Macro2 Options” in Chapter 4,
pages 4-18 and 4-19.
Lines are double spaced instead of
single spaced.
The printer overprints on the same
line.
The next print line starts where the
previous line ended instead of at
the left margin.
The printer overprints on the same
line while the next print line starts
where the previous line ended
instead of at the left margin.