Cabletron Systems 520 - Manual (Page 49)

Configuring the Router
4-3
Examples used in this section show a router power up when the system is
started with factory defaults.
The term “SmrtSwtch Rtr 5xx” is used to imply either the SmartSwitch
Router SSR-510 or the SmartSwitch Router SSR-520. Screens used in this
chapter reflect typical SSR-510 screens. These screens are very similar to
those used for the SSR-520.
6
After the router is powered up, you can verify that it is configured by
connecting to it via the console port or TELNET. The console port will
display the In-band management address that you selected on its menu
display.
If you successfully connect to the router with PING or TELNET, your
configuration has been successfully loaded.
Step Action