Cabletron Systems 520 - Manual (Page 54)

Configuring the Router
4-8
After the EasyStart> prompt displays, quickly type: stop and press <Return>
To access the setup menus, press the <Return> key on the console port device
until the
SmrtSwtch Rtr 5xx INSTALLATION MENU displays.
To configure the router using Go to the section titled
Menus
Using Menus to Set up the Router
(assign IP Address via menus)
Commands
Go to Local Console
(assign IP Address via the CLI
qconfig procedure)
SmrtSwtch Rtr 5xx
=============================================================
SmrtSwtch Rtr 5xx INSTALLATION MENU
[1] Restart with Factory Defaults
[2] Restart with Current Settings
[3] Show Current Settings
[4] IP Configuration
[5] Go to Local Console
=============================================================
Enter selection:
Copyright (c) 1998, Cabletron Systems Inc.
Entering EasyStart operation. Type ‘stop’ to terminate.
ELS messages are automatically displayed in this mode.
MOS Operator Control
EasyStart> Stop <Return>