Cabletron Systems 520 - Manual (Page 53)

Configuring the Router
4-7
After the SmrtSwtch Rtr 5xx INSTALLATION MENU displays twice,
type 3 and press <Return> as shown in the following example:
SmrtSwtch Rtr 5xx
Copyright (C) 1995, Digital Equipment Corporation
SmrtSwtch Rtr 5xx INSTALLATION MENU
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
To fully manage this device telnet to one of the
following IP addresses or select item [3] below.
Out-of-Band: Not Configured
In-Band : None Operational or Configured
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
[1] Restart with Factory Defaults
[2] Restart with Current Settings
[3] Go to Local Console
====================================================================
Enter selection : 00:00:05 EZ.001: Starting.
00:00:06 EZ.007: Waiting up to 30 seconds for devices to pass self-test.
00:00:08 AI.001: Changed params on ifc 1 (Serial Datalink),
from PPP to PSL.
00:00:08 EZ.002: Changed one or more cfg params.
00:00:08 BTP.010: net 0, int Eth/0, Sent client request (htype: 1)
00:00:08 BTP.011: net 1, int PPP/0, Could not snd client req because: Ifc not up
00:00:08 BTP.011: net 2, int ISDN/0, Could not snd client req because: Ifc type not suptd
00:00:09 BTP.010: net 0, int Eth/0, Sent client request (htype: 1)
00:00:09 BTP.011: net 1, int PPP/0, Could not snd client req because: Ifc not up
00:00:09 BTP.011: net 2, int ISDN/0, Could not snd client req because: Ifc type not suptd
00:00:10 BTP.010: net 0, int Eth/0, Sent client request (htype: 1)
00:00:10 BTP.011: net 1, int PPP/0, Could not snd client req because: Ifc not up
00:00:10 BTP.011: net 2, int ISDN/0, Could not snd client req because: Ifc type not suptd
00:00:13 EZ.003: Bootp failed.
00:00:13 EZ.006: All dlinks/parameters tried but failed; resetting to def values.
00:00:13 EZ.009: *** Restarting Router ***
SmrtSwtch Rtr 5xx
====================================================================
SmrtSwtch Rtr 5xx INSTALLATION MENU
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
To fully manage this device telnet to one of the
following IP addresses or select item [3] below.
Out-of-Band: Not Configured
In-Band : None Operational or Configured
* * * * * * * * * * * * * * * * * * * * * * * * * * * * * * *
[1] Restart with Factory Defaults
[2] Restart with Current Settings
[3] Go to Local Console
====================================================================
====================================================================
Enter selection : 3 <Return> 00:00:05 EZ.001: Starting.
Will start FLASH GW image in 5 seconds
Hit <ctl>C or enter cmd with <CR> to abort
Digital RouteAbout Access EW bootstrap monitor V1.0 [Jul 5 1995]
>