Cabletron Systems 520 - Manual (Page 65)

Configuring the Router
4-19
[5] Go To Local Console
This selection runs quick configuration. If you reset to factory defaults and
select
Go to Local Console without having configured the router via
the installation menu, the qconfig process starts automatically.
After making the changes you want, exit quick configuration and apply the
changes you made by typing restart. The system displays the following
messages:
If you type restart at the Config (only)> prompt, the following message
displays:
Enter yes to proceed. The following menu is then displayed.
Quick Config Done
Type RESTART at Config (only)> prompt for the configuration to
take effect.
Config (only) >
Config (only)>restart
Are you sure you want to restart the gateway? (Yes [No]):
SmrtSwtch Rtr 5xx
==================================================================
SmrtSwtch Rtr 5xx INSTALLATION MENU
**************************************************
To fully manage this device telnet to one of the
following IP addresses or select item [3] below.
Out-of-Band: Not Configured
In-Band : 134.1.147.150
**************************************************
[1] Restart with Factory Defaults
[2] Restart with Current Settings
[3] Go to Local Console
==================================================================
Enter selection :