Crest Audio X-SERIES X 20R - Manual (Page 19)

Bus Assignment Features
The bus assignment section offers considerable flexibility for creating what eventually
becomes the main output mix. Two stereo subgroups are available for creating submixes or
separate stereo mixes. All assignments are derived post-fader, post-eq and post-mute.
PAN Control
The pan control positions the signal within the stereo left/right (or odd/even) field.
The PAN pot affects signals that are assigned directly to Left-Right, Groups 1-2 and
Groups 3-4.
MUTE
The input channel is muted and the MUTE LED is illuminated. All AUX feeds (See Aux
options for exceptions) and bus assignments are also muted. Insert send and SOLO
signals remain active.
Mono Bus Assign
The channel is assigned to the MONO mix bus. PAN has no affect on MONO.
L-R Bus Assign
The channel is assigned to the Left and Right mix buses through the PAN pot.
G 1-2 Bus Assign
The channel is assigned to Groups 1 and 2 through the PAN pot. Groups 1 and 2 are
normally treated as a stereo pair. They can also be used as discrete mono groups by
using the PAN control at its full CW or CCW setting.
G 3-4 Bus Assign
The channel is assigned to Groups 3 and 4 through the PAN pot. Groups 3 and 4 are
normally treated as a stereo pair. They can also be used as discrete mono groups by
using the PAN control at its full CW or CCW setting.
Input Fader (100mm)
The fader is the primary level control for signals being sent to any of the console’s
post-fader mix buses.
PK / SIG LED Indicator
This two-color LED is used to monitor the channel’s signal level. Signal present (green)
is monitored pre-fader. Peak (red) is monitored at the preamp and before & after the
fader.
PFL
The PFL (Pre Fader Listen) button routes the channel’s pre-fader (post-insert/post-EQ)
the signal to the Solo bus for monitoring through headphones or in the control room.
The Peak (red) LED is illuminated to show active PFL status.
p. 19
Mono Input Channel
1