Crest Audio X-SERIES X 20R - Manual (Page 35)

Front Panel Features
12 V Lamp Jack
A TNC jack is available for attaching a goose-neck lamp. The center connection is 12
Volts DC and the outer connection is ground. A medium or high-intensity incandescent
or LED 12V DC Littlite can be used. The output voltage is current limited to prevent
faulty bulbs or mis-connection from harming the internal workings of the mixer.
LED Meters - Left And Right
A pair of LED arrays are provided for monitoring the output levels. They follow the
SOLO system, making it easy to adjust input and output levels by PFL’ing and AFL’ing
different sources. They normally show the LEFT and RIGHT output levels. When some-
thing is Soloed, that signal replaces LEFT and RIGHT on the meters.
SOLO LED
This red LED lights up when anything on the mixer is soloed.
PWR LED
This green LED illuminates to indicate that the mixer is powered up.
TAPE IN Level
On the rear panel there are Left and Right TAPE IN connectors, both 1/4” TRS and
RCA. They can be used to bring in a stereo source such as a two-track playback
from tape, CD, MD, or a sampler. This knob controls the level to the Aux 1/2 and
Left/Right buses.
TAPE IN Assignment
TO A1-2 This assigns the stereo TAPE IN to Auxes 1 and 2, which are configured as a
stereo pair. This is useful for stereo program monitoring.
TO L-R This assigns the stereo TAPE IN feed to the Left and Right mix buses. This is
useful for in-between-set background music and as an extra stereo return.
Master Section
3
p. 35