Canon DR-5060F - Manual (Page 10)

8
About the Power Supply
WARNING
■ Be sure to connect to a AC 220-240V (50/60 Hz)/AC 120V (60 Hz) power
supply.
■ Ensure that the scanner is connected to an independent power outlet. Do
not plug the scanner into an outlet shared with another device. If you use an
extension cable, pay attention to the total amperage of the cable.
■ Be sure to connect the ground cable before using the scanner.
Also, never connect the ground cable to gas pipes or water pipes.
■ If you are unsure of anything relating to the power supply, contact your store
of purchase or your local power company.
■ Never place an object on top of the power cord or step on it.
■ Never bundle the power cord or wrap the cord around an object such as a
table leg.
■ Do not tug the power cord. When you remove the power cord, grip it by the
plug head.
■ Keep the area around the power outlet free of obstacles.
Carrying
When you move the DR-5060F, it should be held by the under section of the main
unit by at least two people, and carried carefully.
WARNING
■ When lifting this unit, be sure to hold it by the under section of the main unit,
and never place your hands on opening/closing sections such as the upper
unit.
■ Be sure to move this unit with at least two people. This unit weighs 48 kg
(105.8 lb.). If one person tries to move this unit alone, the person may be
seriously injured.
■ Before you move this unit, always turn the power switch OFF and disconnect
the power cord from the power outlet. Also, disconnect the SCSI cable from
the connector. Moving the scanner with the power still ON or the SCSI cable
still connected might result in electrical shock.
Safety Precautions