Canon DR-5060F - Manual (Page 40)

38
MEMO
If you are using Windows 95/98/Me or Windows 2000, then the first time that
you turn on your PC after connecting this scanner to your PC Window’s Plug
and Play function will automatically display a screen prompting you to install
the scanner driver. (The name of this prompt screen varies among the different
versions of Windows.)
If “New Hardware Found” is displayed (Windows 95), select “Select from a list
of alternative drivers” and click OK. On the next screen, select Other Devices
and then click OK.
If “Update Device Driver Wizard” is displayed (Windows 95), click Next and then
click Finish on the next screen.
If “Add New Hardware Wizard” is displayed (Windows 98), follow the procedure
described below.
1. Click Next.
2. Select “Search for the best driver for your device (Recommended)” and then
click next.
3. Clear all checkmarks and then click Next.
4. Click Next.
5. Click Finish.
If “Add New Hardware Wizard” is displayed (Windows Me), select “Automatic
search for a better driver (Recommended)”, then click Next and then click
Finish on the next screen.
If “Found New Hardware Wizard” is displayed (Windows 2000), follow the
procedure described below.
1. Click Next to advance to the “Install Hardware Device Drivers” screen.
2. Select “Search for a suitable driver for my device (recommended)”, and then
click Next to proceed to the “Locate Driver Files” screen.
3. Clear all of the checkmarks in the “Optional search locations”, and then click
Next to proceed to the “Driver Files Search Results” screen.
4. Select “Disable the device.” and then click Finish.
Turning the Power OFF
1
Turn the computer OFF before you turn the scanner OFF.
CAUTION
● Wait at least 10 seconds before turning the scanner ON again.
● For your safety, disconnect the power plug from the power outlet if you are
not using the scanner for a long time.
Turning the Power ON/OFF